KitchenAid · Washer Serious

FH — No Water Detected (Front Load)

On front-load models, the FH code indicates the washer cannot detect water entering the tub during fill. Similar function to F8E1.

Keep using it?
Limited use only
DIY difficulty
Easy
Verified against
kitchenaid.com ↗

How to fix it

  1. Confirm both supply valves are fully open at wall
  2. Disconnect hoses and clean inlet screens
  3. Inspect hoses for kinks or damage
  4. Verify water pressure (20-100 psi required)
  5. Test water inlet valve and replace if defective

Why it happens

Typical signs: FH displayed · Washer won't fill · Cycle paused at start · Beeping then FH

  • Closed water supply valves Hot/cold faucets shut off
  • Clogged inlet screens Sediment blocking valve filters
  • Kinked/burst supply hose Hose damage restricting flow
  • Defective water inlet valve Solenoid not opening
  • Faulty flowmeter Sensor not detecting water flow

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Button on User Interface F3E1 F3E1 — Pressure Switch Failure F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.