Whirlpool · Oven Moderate

F3E0 — Whirlpool Oven F3 E0 — Oven Temp Sensor Open

F3 E0 means the oven temperature sensor (RTD) circuit reads open, so the control cannot measure oven temperature.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Typical cost
$20-40
Verified against
producthelp.whirlpool.com ↗

The fix

Oven temperature sensor

Oven temperature sensor (RTD) open circuit

$20-40 easy difficulty 30 min Tools: multimeter, screwdriver, nut driver

Diagnose first: Sensor should read about 1080 ohms at room temperature. If reading is correct, check the wiring harness and connector at the back of the oven.

Find this part on Amazon →

As an Amazon Associate we earn from qualifying purchases.

How to fix it

  1. Unplug the oven.
  2. Test the oven sensor (~1080 ohms at room temp); replace if open.
  3. Reseat or repair the sensor connector.

Why it happens

Typical signs: Oven will not heat · F3 E0 on the display

  • Failed oven sensor The RTD probe has gone open.
  • Connector fault A loose/burnt sensor connector at the rear.

Related repair guides

How to Test an Oven Temperature Sensor (RTD) →Oven Not Heating or Not Reaching Temperature →

More Whirlpool oven codes

F0E0 F0E0 — Unrecognized control fault F1E0 F1E0 — Electronic Oven Control (EOC) fault F1E1 F1E1 — EEPROM checksum error F1E2 F1E2 — Control board processor / watchdog fault F2E0 F2 E0 — Stuck Key F2E1 F2E1 — Shorted keypad / cancel key open

All Whirlpool codes → All oven codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.whirlpool.com.