Frigidaire · Oven Serious

F95 — Door Lock / Motor Drive Fault

The EOC detected a fault in the door lock drive circuit — typically the relay or triac that powers the lock motor is not switching correctly.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
frigidaire.com ↗

How to fix it

  1. Cut power.
  2. Unplug the lock motor at the EOC and measure motor resistance — open or near-zero means replace the motor.
  3. Inspect the harness between EOC and latch for damage.
  4. If motor and harness check out, replace the EOC — the lock drive circuit on the board is bad.

Why it happens

Typical signs: F95 on self-clean start · Lock motor never powers up · Code returns immediately after reset

  • Failed lock drive relay on EOC Relay or triac that energizes the lock motor has failed — board-level fault.
  • Shorted lock motor Motor windings shorted, tripping the drive protection.
  • Wiring short between EOC and lock motor Pinched harness creates a short to chassis.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Frigidaire oven door lock motor Common replacement
    Amazon →
  • Frigidaire oven control board Common replacement
    Amazon →

More Frigidaire oven codes

F0 F0 — Touchpad / Membrane Communication Error F1 F1 — Runaway Temperature / Stuck Key (Older Models) F10 F10 — Runaway Temperature F11 F11 — Shorted keypad button F12 Range/Oven F12 — Control Microprocessor Fault F13 Range/Oven F13 — Control Memory (EEPROM) Failure

All Frigidaire codes → All oven codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: frigidaire.com.