KitchenAid · Dishwasher Serious

F6E2 — Water Inlet Valve Electrical Fault

The control detects an electrical problem in the water inlet valve circuit — open winding, short, or wiring fault.

Keep using it?
Limited use only
DIY difficulty
Hard

How to fix it

  1. Power off at the breaker.
  2. Pull the dishwasher forward to access the valve under the front kick panel.
  3. Disconnect the harness and test valve coil resistance with a multimeter (typical ~500-1500 ohms).
  4. Inspect the harness from the valve to the main control board for damage.
  5. Replace the water inlet valve if the coil reads open or shorted.
  6. If the valve and harness check good, replace the main control board.

Why it happens

Typical signs: No water fill · Cycle aborts almost immediately · F6E2 displayed / 6 flashes, 2 flashes

  • Failed water inlet valve solenoid Open or shorted coil winding.
  • Damaged wiring harness Chafed wire or pulled connector to the valve.
  • Failed main control board Triac driving the valve is shorted or open.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • KitchenAid dishwasher water inlet valve Common replacement
    Amazon →
  • KitchenAid dishwasher main control board Common replacement
    Amazon →

More KitchenAid dishwasher codes

6-1 6-1 (F6E1) Error — User Interface / Main Control Error 7-1 7-1 Error — Heating Element Failure 8-1 8-1 (F8E1 / H2O) Error — Not Detecting Water F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F5E1 F5E1 — Door Switch Not Detected

All KitchenAid codes → All dishwasher codes →

Frequently asked questions

What does the F6E2 code mean on a KitchenAid dishwasher?

The control detects an electrical problem in the water inlet valve circuit — open winding, short, or wiring fault.

What causes the F6E2 code on a KitchenAid dishwasher?

Failed water inlet valve solenoid: Open or shorted coil winding. Damaged wiring harness: Chafed wire or pulled connector to the valve. Failed main control board: Triac driving the valve is shorted or open.

Is it safe to keep using a KitchenAid dishwasher with a F6E2 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F6E2 on a KitchenAid dishwasher?

Power off at the breaker. Pull the dishwasher forward to access the valve under the front kick panel. Disconnect the harness and test valve coil resistance with a multimeter (typical ~500-1500 ohms).

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.