KitchenAid · Oven Serious

F7E0 — Latch switch failure

The control cannot confirm the door latch position. Different from F5E1 — this points to the latch switches themselves rather than the motor.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
producthelp.kitchenaid.com ↗

How to fix it

  1. Disconnect power at the breaker.
  2. Remove the oven top trim to access the latch assembly.
  3. Visually inspect microswitches and lever — bend or wear is visible.
  4. Meter each switch for continuity in both latched and unlatched positions.
  5. Replace the door latch assembly (switches usually come as one unit with the motor).

Why it happens

Typical signs: F7E0 on display · Self-clean cycle will not start or aborts · Door reports locked but unlocked or vice versa

  • Failed latch position microswitches Switches that confirm locked/unlocked positions are stuck or broken.
  • Latch out of alignment Mechanical wear preventing switches from being actuated.
  • Harness fault Latch switch wiring damaged.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • KitchenAid oven door latch assembly Common replacement
    Amazon →

More KitchenAid oven codes

F0E0 Range/Oven F0E0 — Electronic Control Fault F1E0 F1E0 — Control board EEPROM/communication fault F1E2 F1E2 — Main relay board failure F1E5 F1E5 — Control calibration / cal data fault F2E0 Range/Oven F2E0 — Keypad / Control Problem F2E1 Range/Oven F2E1 — Keypad / Control Problem

All KitchenAid codes → All oven codes →

Frequently asked questions

What does the F7E0 code mean on a KitchenAid oven?

The control cannot confirm the door latch position. Different from F5E1 — this points to the latch switches themselves rather than the motor.

What causes the F7E0 code on a KitchenAid oven?

Failed latch position microswitches: Switches that confirm locked/unlocked positions are stuck or broken. Latch out of alignment: Mechanical wear preventing switches from being actuated. Harness fault: Latch switch wiring damaged.

Is it safe to keep using a KitchenAid oven with a F7E0 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F7E0 on a KitchenAid oven?

Disconnect power at the breaker. Remove the oven top trim to access the latch assembly. Visually inspect microswitches and lever — bend or wear is visible.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.kitchenaid.com.