Maytag · Oven Serious

F3E1 — Oven Temperature Sensor Shorted

The oven temperature sensor circuit is shorted. The control reads an impossibly low resistance and disables heat.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
producthelp.maytag.com ↗

How to fix it

  1. Disconnect power.
  2. Disconnect sensor at the EOC and measure resistance at the sensor leads.
  3. Replace the sensor if it reads near zero.
  4. Inspect the harness routing for pinch points or melted insulation.
  5. If both are good, replace the electronic oven control.

Why it happens

Typical signs: F3E1 displayed · No heating element activity · Code returns immediately after reset

  • Shorted temperature sensor Internal short in the RTD probe.
  • Pinched / shorted sensor harness Sensor wires pinched against cavity insulation or chassis.
  • Failed EOC Control board input is shorted internally.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Oven temperature sensor Common replacement
    Amazon →

More Maytag oven codes

F1E0 Range/Oven F1E0 — Oven Control or Wiring Problem F1E1 Range/Oven F1E1 — Oven Control or Wiring Problem F1E2 Range/Oven F1E2 — Oven Control or Wiring Problem F2 F2 — Oven Temperature Sensor, Control, or Wiring Problem F2E0 Range/Oven F2E0 — Keypad / Control Problem F3E0 F3E0 — Oven Temperature Sensor Open

All Maytag codes → All oven codes →

Frequently asked questions

What does the F3E1 code mean on a Maytag oven?

The oven temperature sensor circuit is shorted. The control reads an impossibly low resistance and disables heat.

What causes the F3E1 code on a Maytag oven?

Shorted temperature sensor: Internal short in the RTD probe. Pinched / shorted sensor harness: Sensor wires pinched against cavity insulation or chassis. Failed EOC: Control board input is shorted internally.

Is it safe to keep using a Maytag oven with a F3E1 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F3E1 on a Maytag oven?

Disconnect power. Disconnect sensor at the EOC and measure resistance at the sensor leads. Replace the sensor if it reads near zero.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.