Maytag · Oven Serious

F4E1 — Oven Temperature Sensor (RTD) Fault

F4E1 indicates an oven temperature sensor (RTD) circuit fault — open OR shorted (out of range), not exclusively a short. Test the sensor (~1080 ohms at room temperature) and its wiring.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
producthelp.maytag.com ↗

How to fix it

  1. Disconnect power.
  2. Remove the rear access panel and disconnect the probe receptacle harness at the EOC.
  3. Measure resistance across the probe jack leads.
  4. If shorted, replace the probe receptacle / harness.
  5. If the harness reads open with the jack disconnected but the code returns, replace the EOC.

Why it happens

Typical signs: F4E1 displayed · Probe modes unavailable · Code persists even after unplugging the meat probe

  • Shorted internal probe wiring Cavity probe harness pinched or melted against chassis.
  • Shorted probe receptacle Cavity-mounted probe jack has shorted internally.
  • Failed EOC Control board input is shorted internally.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Probe receptacle / harness Common replacement
    Amazon →

More Maytag oven codes

F1E0 Range/Oven F1E0 — Oven Control or Wiring Problem F1E1 Range/Oven F1E1 — Oven Control or Wiring Problem F1E2 Range/Oven F1E2 — Oven Control or Wiring Problem F2 F2 — Oven Temperature Sensor, Control, or Wiring Problem F2E0 Range/Oven F2E0 — Keypad / Control Problem F3E0 F3E0 — Oven Temperature Sensor Open

All Maytag codes → All oven codes →

Frequently asked questions

What does the F4E1 code mean on a Maytag oven?

F4E1 indicates an oven temperature sensor (RTD) circuit fault — open OR shorted (out of range), not exclusively a short. Test the sensor (~1080 ohms at room temperature) and its wiring.

What causes the F4E1 code on a Maytag oven?

Shorted internal probe wiring: Cavity probe harness pinched or melted against chassis. Shorted probe receptacle: Cavity-mounted probe jack has shorted internally. Failed EOC: Control board input is shorted internally.

Is it safe to keep using a Maytag oven with a F4E1 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F4E1 on a Maytag oven?

Disconnect power. Remove the rear access panel and disconnect the probe receptacle harness at the EOC. Measure resistance across the probe jack leads.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.