Maytag · Oven Moderate

F5E0 — Door Switch Fault

The control sees a door switch state that does not match the door latch position. Often shows up around self-clean attempts.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
producthelp.maytag.com ↗

How to fix it

  1. Open and close the door firmly and try a bake cycle.
  2. Disconnect power and remove the rear access panel.
  3. Locate the door switch and test continuity in both door states.
  4. Replace the door switch if it does not change state.
  5. Inspect door hinges for sag and adjust or replace if needed.

Why it happens

Typical signs: F5E0 displayed · Self-clean will not start · Oven light behavior is wrong relative to door state

  • Failed door switch The plunger or microswitch on the door is not opening/closing the circuit correctly.
  • Misaligned door Door hinges have sagged and the switch is not actuated fully.
  • Wiring harness fault Open or short in door switch wiring to the EOC.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More Maytag oven codes

F1E0 Range/Oven F1E0 — Oven Control or Wiring Problem F1E1 Range/Oven F1E1 — Oven Control or Wiring Problem F1E2 Range/Oven F1E2 — Oven Control or Wiring Problem F2 F2 — Oven Temperature Sensor, Control, or Wiring Problem F2E0 Range/Oven F2E0 — Keypad / Control Problem F3E0 F3E0 — Oven Temperature Sensor Open

All Maytag codes → All oven codes →

Frequently asked questions

What does the F5E0 code mean on a Maytag oven?

The control sees a door switch state that does not match the door latch position. Often shows up around self-clean attempts.

What causes the F5E0 code on a Maytag oven?

Failed door switch: The plunger or microswitch on the door is not opening/closing the circuit correctly. Misaligned door: Door hinges have sagged and the switch is not actuated fully. Wiring harness fault: Open or short in door switch wiring to the EOC.

Is it safe to keep using a Maytag oven with a F5E0 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix F5E0 on a Maytag oven?

Open and close the door firmly and try a bake cycle. Disconnect power and remove the rear access panel. Locate the door switch and test continuity in both door states.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.