What causes the E11 code on a Frigidaire washer?

Low water pressure: Household supply below ~20 psi can't fill in time. Partially clogged inlet screens: Common after plumbing work or in homes with hard water. Weak inlet valve solenoid: Coil partially opens — passes some water but not full flow.

Frigidaire · Washer Moderate

E11 — Fill time too long

Water is entering but not fast enough to reach the level within the allowed time. Closely related to E10 but specifically a slow-fill condition.

Keep using it?: Yes, with caution
DIY difficulty: Moderate
Typical cost: $25-60
Verified against: frigidaire.com ↗

The fix

Water inlet valve assembly

Fill time exceeded - water not entering tub fast enough

$25-60 easy difficulty 30 min Tools: screwdriver, nut driver, pliers

Diagnose first: Verify both hot/cold supply valves are open and inlet screens are clean. Low household pressure or partially closed shutoff is very common.

Find this part on Amazon →

Didn't resolve it? Next suspect: Pressure sensor / hose ($25-60)

As an Amazon Associate we earn from qualifying purchases.

How to fix it

Run a separate faucet to confirm normal household water pressure.
Clean inlet valve screens.
Watch for leaks under the washer during fill.
Replace the inlet valve if flow is weak with full pressure upstream.
If problem persists, replace the pressure sensor.

Why it happens

Typical signs: Fill takes much longer than normal · Stops mid-fill with E11 · Low household water pressure

Low water pressure Household supply below ~20 psi can't fill in time.
Partially clogged inlet screens Common after plumbing work or in homes with hard water.
Weak inlet valve solenoid Coil partially opens — passes some water but not full flow.
Leak in tub or hose during fill Water level never rises because it's escaping.

More Frigidaire washer codes

E10 E10 — Water fill problem E13 E13 — Water leak or air leak in pressure system E20 E20 — Drain pump won't pump out E21 E21 — Slow drain / water remains in tub E23 E23 — Drain pump relay fault on control board E31 E31 — Pressure sensor communication failure

All Frigidaire codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: frigidaire.com.