Frigidaire · Washer Moderate

E41 — Door switch open during cycle

The control thinks the door is open when it should be closed and locked. The cycle stops for safety.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Typical cost
$40-90
Verified against
frigidaire.com ↗

The fix

Door lock / latch assembly

Door switch / latch circuit open

$40-90 moderate difficulty 45 min Tools: screwdriver, Torx bits

Diagnose first: Door latch microswitches commonly fail. Check that door is closing fully and strike is aligned before replacing latch.

Find this part on Amazon →

As an Amazon Associate we earn from qualifying purchases.

How to fix it

  1. Open and firmly re-close the door — listen for a solid click.
  2. Move laundry away from the door seal area.
  3. Unplug and reseat the door lock harness connector.
  4. Test door switch continuity with a meter — should close when latched.
  5. Replace the door lock assembly if the switch is bad.

Why it happens

Typical signs: Cycle pauses or won't start · Door lock light flashes · E41 right after pressing Start

  • Door not latched fully Laundry caught in the boot prevents full close.
  • Failed door switch Microswitch contacts inside the lock assembly worn out.
  • Loose harness at door lock Connector unseated from vibration.
  • Cracked strike Plastic latch tongue worn — won't trip the switch.

More Frigidaire washer codes

E10 E10 — Water fill problem E11 E11 — Fill time too long E13 E13 — Water leak or air leak in pressure system E20 E20 — Drain pump won't pump out E21 E21 — Slow drain / water remains in tub E23 E23 — Drain pump relay fault on control board

All Frigidaire codes → All washer codes →

Frequently asked questions

What does the E41 code mean on a Frigidaire washer?

The control thinks the door is open when it should be closed and locked. The cycle stops for safety.

What causes the E41 code on a Frigidaire washer?

Door not latched fully: Laundry caught in the boot prevents full close. Failed door switch: Microswitch contacts inside the lock assembly worn out. Loose harness at door lock: Connector unseated from vibration.

Is it safe to keep using a Frigidaire washer with a E41 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix E41 on a Frigidaire washer?

Open and firmly re-close the door — listen for a solid click. Move laundry away from the door seal area. Unplug and reseat the door lock harness connector.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: frigidaire.com.