Frigidaire · Washer Serious

E52 — Bad signal from tachometer on motor

The motor's tachometer (speed sensor) isn't sending valid pulses, so the control can't regulate spin speed.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
frigidaire.com ↗

How to fix it

  1. Unplug and tip the washer back.
  2. Reseat the small tach connector at the rear of the motor.
  3. Measure tach coil resistance — typically 60 to 150 ohms.
  4. Replace the motor if the tach coil is open.
  5. Replace the motor control board if tach reads fine but code returns.

Why it happens

Typical signs: No spin or weak spin · Drum spins then stops abruptly · E52 shortly after spin starts

  • Loose or broken tach wire Two-pin connector at rear of motor unseats.
  • Failed tach coil on motor Open winding in the speed sensor — check 60-150 ohms.
  • Failed motor control board Input circuit can't read the tach signal.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Frigidaire washer drive motor Common replacement
    Amazon →

More Frigidaire washer codes

E10 E10 — Water fill problem E11 E11 — Fill time too long E13 E13 — Water leak or air leak in pressure system E20 E20 — Drain pump won't pump out E21 E21 — Slow drain / water remains in tub E23 E23 — Drain pump relay fault on control board

All Frigidaire codes → All washer codes →

Frequently asked questions

What does the E52 code mean on a Frigidaire washer?

The motor's tachometer (speed sensor) isn't sending valid pulses, so the control can't regulate spin speed.

What causes the E52 code on a Frigidaire washer?

Loose or broken tach wire: Two-pin connector at rear of motor unseats. Failed tach coil on motor: Open winding in the speed sensor — check 60-150 ohms. Failed motor control board: Input circuit can't read the tach signal.

Is it safe to keep using a Frigidaire washer with a E52 error?

Limited use only. This is rated a serious-severity fault.

How do I fix E52 on a Frigidaire washer?

Unplug and tip the washer back. Reseat the small tach connector at the rear of the motor. Measure tach coil resistance — typically 60 to 150 ohms.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: frigidaire.com.