LG · Oven Serious

F27 — Cooling fan stalled during self-clean

The cooling fan (which protects the controls during self-clean) is not detected running for more than one minute, so the control aborts the cycle and locks out further heat until cleared.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
lg.com ↗

How to fix it

  1. Let the oven cool fully — the cavity can stay over 500°F well after F27 trips.
  2. Power off at the breaker for 60 seconds.
  3. Pull the top control panel/back panel and locate the cooling fan; verify the blade spins freely with no obstructions.
  4. Reseat the fan harness at the fan and at the main PCB.
  5. With power restored and the oven calling for the fan, measure voltage at the fan plug; if voltage is present and the fan does not run, replace the cooling fan motor.
  6. If no voltage at the fan plug, replace the main control board.

Why it happens

Typical signs: F27 or F-27 on display during or after self-clean · Oven exterior or control panel got unusually hot · No fan noise from the top vent · Self-clean cancels partway through

  • Seized cooling fan motor Bearings or motor windings failed.
  • Obstruction blocking the fan Insulation or debris jammed the blade.
  • Loose or burned harness at the cooling fan Connector dropped voltage.
  • Failed cooling fan relay on main control board Board commands fan on but contacts never close.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • LG oven cooling fan motor Common replacement
    Amazon →

More LG oven codes

All LG codes → All oven codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: lg.com.