Maytag · Dishwasher Serious

F6E2 — Water Inlet Valve Failure

The control activated the inlet valve but did not see the expected fill, or the valve is electrically failed. Cycle aborts before wash.

Keep using it?
Limited use only
DIY difficulty
Moderate

How to fix it

  1. Power down at the breaker for 5 minutes and retry.
  2. Verify house water pressure at the kitchen sink (should be 20-120 psi).
  3. Remove and inspect the inlet screen at the valve; clean any grit.
  4. With power off, ohm-test the inlet valve solenoid (500-1500 ohms typical).
  5. Reseat the harness connector at the valve.
  6. Replace the inlet valve if out of spec or visibly leaking.

Why it happens

Typical signs: No fill or very slow fill · Cycle stalls at start · Audible buzz from valve area · Repeated F6E2 after reset

  • Failed inlet valve solenoid Coil burned open after years of use.
  • Low household water pressure Below ~20 psi the valve doesn't open reliably.
  • Clogged inlet screen Sediment restricts flow below the threshold.
  • Disconnected harness at the valve Connector knocked loose during cabinet work.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag dishwasher inlet valve Common replacement
    Amazon →

More Maytag dishwasher codes

F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F2E2 F2E2 — User Interface Communication Error F3E1 F3E1 — Thermistor / OWI Sensor Failure F3E2 F3E2 — Thermistor Open / Out of Range F4E1 F4E1 — Heater Circuit Fault

All Maytag codes → All dishwasher codes →

Frequently asked questions

What does the F6E2 code mean on a Maytag dishwasher?

The control activated the inlet valve but did not see the expected fill, or the valve is electrically failed. Cycle aborts before wash.

What causes the F6E2 code on a Maytag dishwasher?

Failed inlet valve solenoid: Coil burned open after years of use. Low household water pressure: Below ~20 psi the valve doesn't open reliably. Clogged inlet screen: Sediment restricts flow below the threshold.

Is it safe to keep using a Maytag dishwasher with a F6E2 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F6E2 on a Maytag dishwasher?

Power down at the breaker for 5 minutes and retry. Verify house water pressure at the kitchen sink (should be 20-120 psi). Remove and inspect the inlet screen at the valve; clean any grit.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.