Maytag · Dishwasher Moderate

F9E2 — Drain Fault (Water Not Draining)

Maytag lists the potential cause of F9E2 as a drain motor error. Its checks: on a new installation, make sure the garbage-disposer knockout plug was removed and the drain hose is routed correctly inside the frame; check the disposer and drain for clogs; straighten a kinked drain hose.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
producthelp.maytag.com ↗ Maytag Product Help: F9E2 - Dishwasher

How to fix it

  1. Pull the filters out of the sump and rinse them thoroughly under hot water.
  2. Check the drain hose at the disposal/air gap for kinks or food clogs.
  3. If recently installed, confirm the garbage disposal knockout plug was removed.
  4. Bail out standing water, remove the drain pump cover, and clear any glass or food debris from the impeller.
  5. Run a drain-only cycle to confirm normal drain time (~60-90 seconds).
  6. Replace the drain pump if it hums but won't pump or won't run at all.

Why it happens

Typical signs: Standing water in the tub · Drain pump runs long or constantly · Dishes come out wet at bottom · Gurgling noise at end of cycle

  • Clogged drain hose or air gap Food debris or grease restricts flow.
  • Plugged sink garbage disposal knockout On new installs, the knockout in the disposal was never removed.
  • Failed drain pump Impeller jammed or motor open.
  • Clogged sump filter Coarse and fine filters not cleaned regularly.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag dishwasher drain pump Common replacement
    Amazon →

Related repair guides

How to Clean a Dishwasher Filter (And Why Your Dishes Aren't Clean) →

More Maytag dishwasher codes

F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F2E2 F2E2 — Main Control Communication Error F3E1 F3E1 — Thermistor / OWI Sensor Failure F3E2 F3E2 — Thermistor or OWI Sensor Fault F4E1 F4E1 — Heater Circuit Fault

All Maytag codes → All dishwasher codes →

Frequently asked questions

What does the F9E2 code mean on a Maytag dishwasher?

Maytag lists the potential cause of F9E2 as a drain motor error. Its checks: on a new installation, make sure the garbage-disposer knockout plug was removed and the drain hose is routed correctly inside the frame; check the disposer and drain for clogs; straighten a kinked drain hose.

What causes the F9E2 code on a Maytag dishwasher?

Clogged drain hose or air gap: Food debris or grease restricts flow. Plugged sink garbage disposal knockout: On new installs, the knockout in the disposal was never removed. Failed drain pump: Impeller jammed or motor open.

Is it safe to keep using a Maytag dishwasher with a F9E2 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix F9E2 on a Maytag dishwasher?

Pull the filters out of the sump and rinse them thoroughly under hot water. Check the drain hose at the disposal/air gap for kinks or food clogs. If recently installed, confirm the garbage disposal knockout plug was removed.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.