Maytag · Microwave Serious

F1E2 — Control / User-Interface Fault

On Maytag combination microwave-ovens, the F1Ex family points to a microwave user-interface or control fault (or its wiring). The specific "non-volatile memory failed" meaning is not confirmed in Maytag documentation — treat F1E2 as a control/UI fault and confirm the exact sub-meaning for your model.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
producthelp.maytag.com ↗

How to fix it

  1. Unplug the microwave for 5 minutes to attempt a soft reset.
  2. Restore power and observe — if F1E2 persists, the memory is bad.
  3. Check that the microwave is on a dedicated 20A circuit at proper voltage.
  4. Replace the main control board (ACU).
  5. After replacement, verify clock and settings save through a power cycle.

Why it happens

Typical signs: F1E2 at startup · Settings reset randomly · Microwave nonfunctional

  • Corrupted EEPROM Power surge or component aging corrupted stored data.
  • Failed control board Memory chip on ACU has failed.
  • Low/unstable line voltage Brownouts during writes corrupted EEPROM.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag microwave main control board (ACU) Common replacement
    Amazon →

More Maytag microwave codes

door 'door' — Door Not Closed / Open Reminder F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Key on Keypad F2E2 F2E2 — User Interface Mismatch F3E1 F3E1 — Humidity Sensor Failure F4E1 F4E1 — Cavity Temperature Thermistor Fault

All Maytag codes → All microwave codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.