Whirlpool · Dishwasher Moderate

F6E2 — Water Inlet Valve Circuit Open

F6E2 indicates an open circuit in the water inlet valve windings — the control cannot drive the inlet valve. Check the inlet valve solenoid and its wiring. (It is specifically the inlet valve, not the diverter.)

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
producthelp.whirlpool.com ↗

How to fix it

  1. Power off at the breaker and shut off the water supply.
  2. Pull the toe-kick and locate the inlet valve at the bottom-left front of the dishwasher.
  3. Unplug the valve and measure resistance across its terminals — replace if not in the ~1,400 ohm range.
  4. Inspect the wire connectors for corrosion and reseat firmly.
  5. If the valve tests good, replace the control board.

Why it happens

Typical signs: F6E2 on display · No fill or partial fill · Cycle aborts at fill phase

  • Failed inlet valve solenoid coil Open or shorted coil — resistance should read ~1,400 ohms.
  • Loose wire on inlet valve Connector at the valve has backed off or corroded.
  • Failed control board triac driving the valve Less common; rule out the valve first.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Whirlpool dishwasher water inlet valve Common replacement
    Amazon →

More Whirlpool dishwasher codes

F1E1 F1E1 — Control Module Fault F1E2 F1E2 — Incompatible or Failed Control Board F2 F2 — Water leak detected F3E1 F3E1 — Thermistor/OWI Sensor Open F3E3 F3E3 — OWI Calibration Failure / Bad Check Valve F4E3 F4E3 — Heating Error

All Whirlpool codes → All dishwasher codes →

Frequently asked questions

What does the F6E2 code mean on a Whirlpool dishwasher?

F6E2 indicates an open circuit in the water inlet valve windings — the control cannot drive the inlet valve. Check the inlet valve solenoid and its wiring. (It is specifically the inlet valve, not the diverter.)

What causes the F6E2 code on a Whirlpool dishwasher?

Failed inlet valve solenoid coil: Open or shorted coil — resistance should read ~1,400 ohms. Loose wire on inlet valve: Connector at the valve has backed off or corroded. Failed control board triac driving the valve: Less common; rule out the valve first.

Is it safe to keep using a Whirlpool dishwasher with a F6E2 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix F6E2 on a Whirlpool dishwasher?

Power off at the breaker and shut off the water supply. Pull the toe-kick and locate the inlet valve at the bottom-left front of the dishwasher. Unplug the valve and measure resistance across its terminals — replace if not in the ~1,400 ohm range.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.whirlpool.com.