Whirlpool · Dishwasher Serious

F8E2 — Water Inlet (Fill) Valve Electrical Fault

Whirlpool lists the potential cause of F8E2 as a fill valve electric error: a problem in the water inlet (fill) valve circuit.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
producthelp.whirlpool.com ↗ Whirlpool Product Help: F8E2- Dishwasher

How to fix it

  1. Remove the drip tray and inspect the inlet valve connection; make sure nothing is leaking.
  2. Cycle power: unplug the dishwasher for 30 seconds (or, if it is hard-wired, switch off its breaker for 30 seconds), then restore power. If the code returns, schedule service.

Why it happens

Typical signs: F8E2 on display · Drain pump silent during drain · Standing water at end of cycle

  • Water inlet (fill) valve electrical fault Whirlpool names a fill valve electric error as the potential cause.
  • Inlet valve connection Whirlpool has you inspect the inlet valve connection behind the drip tray.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Whirlpool dishwasher water inlet valve Common replacement
    Amazon →

More Whirlpool dishwasher codes

F1E1 F1E1 — Control Module Fault F1E2 F1E2 — Incompatible or Failed Control Board F2 F2 — Water leak detected F3E1 F3E1 — Thermistor/OWI Sensor Open F3E3 F3E3 — OWI Calibration Failure / Bad Check Valve F4E3 F4E3 — Heating Error

All Whirlpool codes → All dishwasher codes →

Frequently asked questions

What does the F8E2 code mean on a Whirlpool dishwasher?

Whirlpool lists the potential cause of F8E2 as a fill valve electric error: a problem in the water inlet (fill) valve circuit.

What causes the F8E2 code on a Whirlpool dishwasher?

Water inlet (fill) valve electrical fault: Whirlpool names a fill valve electric error as the potential cause. Inlet valve connection: Whirlpool has you inspect the inlet valve connection behind the drip tray.

Is it safe to keep using a Whirlpool dishwasher with a F8E2 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F8E2 on a Whirlpool dishwasher?

Remove the drip tray and inspect the inlet valve connection; make sure nothing is leaking. Cycle power: unplug the dishwasher for 30 seconds (or, if it is hard-wired, switch off its breaker for 30 seconds), then restore power. If the code returns, schedule service.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.whirlpool.com.