Amana · Dryer Serious

F01 — Main Control Board Failure

The Main Electronic Control Board (MCU/ACU) has detected an internal fault. Dryer typically will not start or behaves erratically.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
amana.com ↗

How to fix it

  1. Unplug the dryer for 5 minutes to reset.
  2. If F01 returns, unplug and inspect harness connections at the main control.
  3. Reseat all connectors and verify locking tabs engage.
  4. If code persists with harnesses good, replace the main electronic control board.
  5. Note the part number on the existing board to match exact replacement.

Why it happens

Typical signs: F01 on display · Dryer will not start · Buttons unresponsive · Random cycle behavior

  • Failed main control board Internal component failure on the ACU — power surge or age.
  • Loose harness to control Connector worked loose after vibration or service.
  • Moisture damage on board Humid laundry room corroded board traces.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dryer main control board (ACU) Common replacement
    Amazon →

More Amana dryer codes

AF AF — Restricted Air Flow E1 E1 — Thermistor Open (legacy display) E2 E2 — Thermistor Shorted (legacy display) Ed Ed — End of cycle / drying complete indication issue F02 F02 — Keypad / User Interface Stuck F22 F22 — Outlet Thermistor Fault

All Amana codes → All dryer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.