PF — Power Failure
Power Failure code indicates the dryer lost power during a cycle. The control board detected an unexpected interruption to the incoming AC power.
- Keep using it?
- Yes — fix when convenient
- DIY difficulty
- Easy
- Verified against
- producthelp.amana.com ↗
How to fix it
- Press Start to resume the cycle or Cancel to clear the code.
- Check the home breaker for the dryer — reset fully off then on.
- Inspect the power cord at the back of the dryer; tighten the three terminal screws after unplugging.
- Check the outlet with a multimeter for steady 240V (L1-L2) and 120V on each leg to neutral.
- If PF appears with no outage occurring, replace the main electronic control board.
Why it happens
Typical signs: PF flashes on display after a power outage · Cycle stopped mid-run · Dryer beeps until acknowledged
- Brief power outage or brownout Most common cause — utility blip or breaker trip interrupted the cycle.
- Loose power cord connection Cord terminals at the dryer block or outlet not fully seated, especially after install or move.
- Tripped or weak breaker 240V breaker partially tripped — one leg dropped out momentarily.
- Failed control board If PF recurs with no actual outage, the main control may be misreading line voltage.
Parts you may need
If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.
More Amana dryer codes
Frequently asked questions
What does the PF code mean on a Amana dryer?
Power Failure code indicates the dryer lost power during a cycle. The control board detected an unexpected interruption to the incoming AC power.
What causes the PF code on a Amana dryer?
Brief power outage or brownout: Most common cause — utility blip or breaker trip interrupted the cycle. Loose power cord connection: Cord terminals at the dryer block or outlet not fully seated, especially after install or move. Tripped or weak breaker: 240V breaker partially tripped — one leg dropped out momentarily.
Is it safe to keep using a Amana dryer with a PF error?
Yes — fix when convenient. This is rated a minor-severity fault.
How do I fix PF on a Amana dryer?
Press Start to resume the cycle or Cancel to clear the code. Check the home breaker for the dryer — reset fully off then on. Inspect the power cord at the back of the dryer; tighten the three terminal screws after unplugging.
Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.amana.com.