E07 — Water Leak Detected (AquaStop)

How to fix it

1. Unplug, tip the washer back slightly, and check the base pan for water.
2. Dry the pan thoroughly with towels and verify the float drops back down.
3. Inspect the door bellows for tears, especially at the bottom fold.
4. Open the cabinet and inspect all internal hoses and clamps.
5. Replace the door boot, sump hose, or dispenser as required.
6. Power back on; if error persists with dry pan, replace the AquaStop sensor.

Why it happens

Typical signs: Drain pump runs nonstop · No water filling · Floor wet around base · Error appears at start of cycle

• Leaking door seal (bellows) Cracked or torn boot drips onto base pan.
• Loose hose clamp inside cabinet Internal hose connection loose, dripping slowly.
• Cracked dispenser housing Detergent compartment hairline crack.
• Tub-to-pump hose split Sump hose at bottom of tub deteriorated.
• False trip from AquaStop float Float in base pan stuck up after past spill.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

• Door bellows seal Common replacement
  Amazon →
• Tub-to-pump sump hose Common replacement
  Amazon →

More Bosch washer codes

All Bosch codes → All washer codes →