Bosch · Washer Moderate
E32 — Unbalanced Load / Vibration Fault
Per Bosch's official US error-code page (listed as E32/F32), an imbalance has been detected. If the imbalance is too large, Bosch states the spin cycle will not run, or it will reduce its speed to protect the appliance.
- Keep using it?
- Yes, with caution
- DIY difficulty
- Moderate
- Verified against
- bosch-home.com ↗
How to fix it
- Open the door and redistribute the load evenly around the drum.
- For very small or single-item loads, add a few more items to balance.
- Place a level on top of the washer; adjust the leveling feet so it sits flat.
- Check all four feet for firm contact with the floor.
- If shaking persists with a balanced load, inspect tub shocks and springs.
- Replace shock absorbers in pairs if worn or oil-leaking.
Why it happens
Typical signs: Excessive shaking during spin · Clothes come out very wet · Washer 'walks' across floor · Cycle ends without full spin
- Single heavy item in drum Comforter, jeans, or rug bunched on one side.
- Small load not redistributable Only 1-2 items can't be balanced automatically.
- Washer not level Uneven feet allow excessive movement.
- Failed shock absorbers Worn dampers can't control tub motion.
- Broken suspension spring Tub sags, hits cabinet at higher RPM.
Parts you may need
If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.
More Bosch washer codes
Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: bosch-home.com.