Frigidaire · Dishwasher Moderate

i10 — Water Not Detected (Fill)

i10 is not listed on owner.frigidaire.com's dishwasher error-code guide (which documents i20 for drain issues and i40 for a clogged filter, but not i10). The 'water not detected during fill' meaning below matches Electrolux/Frigidaire-family service literature but is not confirmed on an official Frigidaire consumer page — verify against your model's manual.

Keep using it?
Yes, with caution
DIY difficulty
Easy

How to fix it

  1. Confirm the under-sink supply valve is fully open.
  2. Clean the inlet valve screen.
  3. Test and replace the inlet valve if needed.

Why it happens

Typical signs: Dishwasher will not fill · Cycle stalls · i10 on the display

  • Supply valve closed / low pressure The under-sink valve must be open with normal pressure.
  • Clogged inlet valve screen Sediment in the inlet valve mesh.
  • Faulty inlet valve A valve that will not open.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Frigidaire Dishwasher Inlet Valve Common replacement
    Amazon →

Related repair guides

Dishwasher Not Filling With Water — Causes and Fixes →

More Frigidaire dishwasher codes

Cd Cd — Door Not Closed / Latched CL CL — Close the door ER ER — General electronic control fault Hot Hot — Water inlet too hot HS HS — Wash Motor Hall Sensor Error i20 i20 — Drain Blocked

All Frigidaire codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.