GE · Dishwasher Moderate

FILL — Fill Time Exceeded

FILL (or 'h2O' / blinking 'Add Water') indicates the dishwasher did not fill to the expected level in the allotted time. Similar root cause to C2 on display models.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
geappliances.com ↗

How to fix it

  1. Verify the under-sink supply valve is fully open.
  2. Shut off water, disconnect supply line, and inspect the inlet valve screen for grit.
  3. Inspect the supply hose for kinks behind the dishwasher.
  4. Confirm the float in the tub front-left moves freely and seats fully down.
  5. If fill is still slow with good pressure, replace the water inlet valve.

Why it happens

Typical signs: FILL or h2O on display · Long pause before cycle starts · Wash arms not spinning (insufficient water)

  • Supply valve closed or low pressure Under-sink valve partially closed or house pressure below ~20 psi.
  • Clogged inlet valve screen Sediment blocking the valve inlet filter.
  • Frozen or kinked supply line Winter freeze on a cold exterior wall, or installer kinked the braided line.
  • Stuck-up float Float jammed up by debris, telling the control the tub is already full.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • GE dishwasher water inlet valve Common replacement
    Amazon →

More GE dishwasher codes

1h 1h — Delay Start Active 888 888 — Display Self-Test / Demo C1 C1 Error — Slow Drain (Over 2 Minutes) C2 C2 Error — Drain Cycle Too Long (Over 7 Minutes) C4 C4 — Overfill / Filled Twice After Power Loss C5 C5 — Underfill / Short Drain Time

All GE codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: geappliances.com.