GE · Dishwasher Serious

LEAK — Detected — Cycle Cancelled

On Floor-Protect models, "Leak Detected" means the base sensor found water and cancelled the cycle to prevent floor damage.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
products.geappliances.com ↗

How to fix it

  1. Unplug the dishwasher and pull it out to inspect hoses, the pump, and the valve.
  2. Tighten or replace the leaking component and dry the base pan.
  3. Restore power; the code clears once the base is dry.

Why it happens

Typical signs: Cycle cancels · Water under the unit · Leak Detected message

  • Damaged or loose hose A leaking or loosened hose connection drips into the base.
  • Pump or valve leak A leaking pump seal or inlet valve.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Dishwasher Hose & Clamp Kit Common replacement
    Amazon →

More GE dishwasher codes

1h 1h — Delay Start Active 888 888 — Display Self-Test / Demo C1 C1 Error — Slow Drain (Over 2 Minutes) C2 C2 Error — Drain Cycle Too Long (Over 7 Minutes) C4 C4 — Overfill / Filled Twice After Power Loss C5 C5 — Underfill / Short Drain Time

All GE codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: products.geappliances.com.