iRobot · Robot Vacuum Moderate
Error 25 — Reboot required
Robot detected an internal issue and requires a reboot. Often a transient fault.
- Keep using it?
- Yes, with caution
- DIY difficulty
- Moderate
- Verified against
- homesupport.irobot.com ↗
How to fix it
- Press and hold CLEAN for 20 seconds (i/j/s/Combo) or 10 seconds (600/900) until the robot powers down.
- Wait 10 seconds, then press CLEAN to power on.
- In the iRobot HOME app, check for and install any firmware updates.
- If error persists, factory reset via app: Product Settings → Remove/Factory Reset.
- If error continues after factory reset, contact iRobot support — likely a hardware failure.
Why it happens
Typical signs: 'Error 25, reboot Roomba' · Robot unresponsive to commands · Random behavior before error
- Temporary firmware glitch Soft hang resolved with reboot.
- Firmware update interrupted An OTA update did not complete cleanly.
- Failing memory or logic board Recurring Error 25 points to hardware degradation.
More iRobot robot vacuum codes
Charging Error 2 Charging Error 2 — Battery not detected Charging Error 3 Charging Error 3 — Battery won't charge Charging Error 5 Charging Error 5 — Charging system fault Error 1 Error 1 — Side wheel stuck / off ground Error 10 Error 10 — Drive wheel not turning Error 11 Error 11 — Bin full or airflow blocked
Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: homesupport.irobot.com.