Maytag · Washer Serious

F1E1 — Main control board failure

The Central Control Unit (CCU) detected an internal fault or cannot communicate with critical subsystems. Often requires control replacement.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
maytag.com ↗

How to fix it

  1. Unplug the washer for 5 minutes to attempt a soft reset.
  2. Plug back in and try a Rinse + Spin cycle.
  3. If error returns, unplug and access the control (top-load: rear console; front-load: top panel).
  4. Inspect for moisture, burn marks, or loose connectors — reseat all harnesses.
  5. If the board is damaged or fault persists, replace the CCU/main control assembly.
  6. After install, run a diagnostic cycle to confirm clear.

Why it happens

Typical signs: F1E1 on display · Washer will not start or hangs mid-cycle · Unresponsive buttons · Random reboots

  • CCU EEPROM corruption or hardware failure Internal fault on the main board.
  • Power surge or brown-out Voltage event scrambled control firmware.
  • Moisture intrusion on control board Leak from above drips on electronics.
  • Loose harness to CCU Vibration loosened a connector.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag washer main control board (CCU) Common replacement
    Amazon →

More Maytag washer codes

E1 F9 E1 F9 — Long drain time F0E1 F0E1 — Load detected during cleaning cycle F21 F21 — Long Drain / Drain Error F22 F22 — Door lock fault (front-load) F2E1 F2E1 — Stuck key on user interface F33 F33 — Pump driver / electrical fault

All Maytag codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: maytag.com.