Amana · Dishwasher Serious

Clean Light Flashing 7 Times — Amana Dishwasher Clean Light Flashing 7x — Heating Element Failure

On Amana models without a digital display, the Clean light flashing seven times indicates the heating element is not reaching expected temperature.

Keep using it?
Limited use only
DIY difficulty
Moderate

How to fix it

  1. Disconnect power and remove the lower kickplate.
  2. Access the heating element terminals under the dishwasher.
  3. Test the heating element for continuity (~10-30 ohms).
  4. Replace the heating element if open.
  5. Inspect terminals and harness for burn damage.

Why it happens

Typical signs: Dishes not drying · Cold water in tub · Clean light flashes 7 times after cycle

  • Burned-out heating element Open circuit in the heater.
  • Failed high-limit thermostat Thermal fuse tripped.
  • Broken wire to heating element Connector burned at element terminal.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher heating element Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Module Fault (F1E1) F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F4E2 F4E2 — Heating System Fault F6E1 F6E1 — User Interface / Main Control Error F7E1 F7E1 — Flow Meter Fault

All Amana codes → All dishwasher codes →

Frequently asked questions

What does the Clean Light Flashing 7 Times code mean on a Amana dishwasher?

On Amana models without a digital display, the Clean light flashing seven times indicates the heating element is not reaching expected temperature.

What causes the Clean Light Flashing 7 Times code on a Amana dishwasher?

Burned-out heating element: Open circuit in the heater. Failed high-limit thermostat: Thermal fuse tripped. Broken wire to heating element: Connector burned at element terminal.

Is it safe to keep using a Amana dishwasher with a Clean Light Flashing 7 Times error?

Limited use only. This is rated a serious-severity fault.

How do I fix Clean Light Flashing 7 Times on a Amana dishwasher?

Disconnect power and remove the lower kickplate. Access the heating element terminals under the dishwasher. Test the heating element for continuity (~10-30 ohms).

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.