Amana · Dishwasher Serious

F6E1 — No Water Detected

The dishwasher started a fill cycle but never sensed water arriving in the tub.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
amana.com ↗

How to fix it

  1. Verify the water supply shutoff valve under the sink is fully open.
  2. Disconnect power and water; inspect the inlet valve screen for debris.
  3. Test the inlet valve coil for ~1000-1500 ohms resistance.
  4. Replace the water inlet valve if open or shorted.
  5. If the valve is good, replace the OWI sensor.

Why it happens

Typical signs: Dry tub after fill phase · Long delay before error · No spray action · F6E1 on display

  • Closed water supply valve Shutoff under sink turned off.
  • Failed water inlet valve Solenoid open or stuck closed.
  • Clogged inlet screen Sediment blocks water flow.
  • Failed OWI sensor Sensor can't detect water that is present.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher water inlet valve Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Lockout Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F4E1 F4E1 — Door Switch Open

All Amana codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.