Amana · Dishwasher Serious

F1E1 — Control Board Failure

The electronic control board has detected an internal fault and cannot continue normal operation.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
producthelp.amana.com ↗

How to fix it

  1. Disconnect power for 5 minutes to attempt a hard reset.
  2. Restore power and try a Normal cycle.
  3. If error returns, inspect the control board for visible burn marks or corrosion.
  4. Replace the main electronic control board.
  5. Verify operation through a complete cycle.

Why it happens

Typical signs: Dishwasher will not start · Buttons unresponsive · Cycle stops mid-wash · Error displayed or flashing LEDs

  • Defective main control board Internal microprocessor or memory fault.
  • Power surge damage Voltage spike corrupted control firmware or fried a component.
  • Moisture intrusion into control housing Steam or leaks can short the board.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher main control board Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Module Fault (F1E1) Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F2E1 F2E1 — Stuck Key on Control Panel F4E2 F4E2 — Heating System Fault F6E1 F6E1 — User Interface / Main Control Error F7E1 F7E1 — Flow Meter Fault

All Amana codes → All dishwasher codes →

Frequently asked questions

What does the F1E1 code mean on a Amana dishwasher?

The electronic control board has detected an internal fault and cannot continue normal operation.

What causes the F1E1 code on a Amana dishwasher?

Defective main control board: Internal microprocessor or memory fault. Power surge damage: Voltage spike corrupted control firmware or fried a component. Moisture intrusion into control housing: Steam or leaks can short the board.

Is it safe to keep using a Amana dishwasher with a F1E1 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F1E1 on a Amana dishwasher?

Disconnect power for 5 minutes to attempt a hard reset. Restore power and try a Normal cycle. If error returns, inspect the control board for visible burn marks or corrosion.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.amana.com.