Amana · Dishwasher Serious

F8E1 — Low Water / Slow Fill

The dishwasher is detecting a slower-than-normal fill rate, suggesting restricted water supply.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
amana.com ↗

How to fix it

  1. Verify the water supply valve under the sink is fully open.
  2. Check the inlet hose for kinks behind the dishwasher.
  3. Disconnect water and clean the inlet valve screen.
  4. Verify household water pressure is at least 20 PSI.
  5. Replace the water inlet valve if the screen is permanently clogged.

Why it happens

Typical signs: Long fill time · Poor cleaning results · Cycle pauses during fill · F8E1 displayed

  • Partially closed supply valve Shutoff valve not fully open.
  • Kinked inlet hose Hose pinched behind dishwasher.
  • Clogged inlet valve screen Mineral or sediment buildup.
  • Low household water pressure Should be 20-120 PSI.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher water inlet valve Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Lockout Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F4E1 F4E1 — Door Switch Open

All Amana codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.