Amana · Dishwasher Serious

F9E1 — Drain Failure

The dishwasher cannot pump water out of the tub within the expected drain time.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
amana.com ↗

How to fix it

  1. Clean the dishwasher filter and sump area.
  2. Disconnect drain hose from disposal/air gap and check for blockage.
  3. If newly installed, verify the disposal knockout plug was removed.
  4. Test drain pump for ~50-200 ohms resistance.
  5. Replace the drain pump if defective.

Why it happens

Typical signs: Standing water in tub bottom · Cycle stops with water remaining · Humming drain pump

  • Clogged drain hose Food debris or kink restricting flow.
  • Clogged garbage disposal port Knockout plug never removed at install.
  • Failed drain pump Impeller jammed or motor burned out.
  • Clogged filter / sump Debris blocking pump intake.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher drain pump Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Lockout Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F4E1 F4E1 — Door Switch Open

All Amana codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.