Amana · Dishwasher Serious

F9E2 — Drain Pump Electrical Fault

The control detected an open or shorted drain pump circuit.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
producthelp.amana.com ↗

How to fix it

  1. Disconnect power and remove the lower kickplate.
  2. Inspect drain pump wire harness for damage.
  3. Test pump resistance — should be ~50-200 ohms.
  4. Replace the drain pump if out of spec.
  5. If pump is good, replace the main control board.

Why it happens

Typical signs: No drain pump operation · Standing water · Cycle aborts at drain phase

  • Open drain pump winding Motor coil failed internally.
  • Loose or burned connector Wire harness damage at pump.
  • Control board relay failure Pump output driver burned out.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher drain pump Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Module Fault (F1E1) Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F4E2 F4E2 — Heating System Fault F6E1 F6E1 — User Interface / Main Control Error

All Amana codes → All dishwasher codes →

Frequently asked questions

What does the F9E2 code mean on a Amana dishwasher?

The control detected an open or shorted drain pump circuit.

What causes the F9E2 code on a Amana dishwasher?

Open drain pump winding: Motor coil failed internally. Loose or burned connector: Wire harness damage at pump. Control board relay failure: Pump output driver burned out.

Is it safe to keep using a Amana dishwasher with a F9E2 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F9E2 on a Amana dishwasher?

Disconnect power and remove the lower kickplate. Inspect drain pump wire harness for damage. Test pump resistance — should be ~50-200 ohms.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.amana.com.