Frigidaire · Dryer Serious

E64 — Heating element open circuit

The dryer expects current draw through the heating element and sees none — either the element is burned out, a thermal fuse has opened, or there's a break in the heater circuit. Most common Frigidaire dryer code.

Keep using it?
Limited use only
DIY difficulty
Moderate
Typical cost
$30-70
Verified against
frigidaire.com ↗

The fix

Heating element

Heating element open circuit

$30-70 moderate difficulty 1 hour Tools: screwdriver, nut driver, multimeter

Diagnose first: Heating element coil broken. Check for clogged vent (root cause of most heater failures) and replace thermal fuse at the same time.

Find this part on Amazon →

Didn't resolve it? Next suspect: Dryer thermal fuse ($10-20)

As an Amazon Associate we earn from qualifying purchases.

How to fix it

  1. Unplug the dryer.
  2. Verify 240V at the outlet (both legs hot to ground).
  3. Remove rear access panel.
  4. Measure heating element resistance — should be ~10–50 ohms. Infinite = replace element.
  5. Test thermal fuse for continuity — must read closed; if open, replace AND inspect vent.
  6. Test high-limit thermostat for continuity.
  7. Clean entire vent run from machine to exterior hood.
  8. Reassemble and run a heat test cycle.

Why it happens

Typical signs: E64 shown on display · Drum tumbles but no heat · Clothes still wet at end of cycle · Cycle completes but cold

  • Burned-out heating element Open coil — most common cause. Element resistance reads infinite.
  • Blown thermal fuse on blower housing Usually a symptom of restricted vent; replace fuse AND clear vent.
  • Open high-limit thermostat Tripped from prior overheat.
  • Broken wire in heater circuit Especially around drum contact points.
  • House supply only delivering 120V (one leg lost) Electric dryer needs 240V — verify both legs hot at outlet.

Other parts sometimes needed

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Frigidaire high-limit thermostat Common replacement
    Amazon →

Related repair guides

Dryer Runs But Doesn't Heat — Causes and Fixes →

More Frigidaire dryer codes

E11 E11 — Control Board Checksum (Memory) Error E4A E4A — Program Time Out Fault E5B E5B — Heater Fault (No Heating) E61 E61 — Heater relay failure on control board E62 E62 — Heater Power Relay Fault E66 E66 — Thermal Limiter Open Circuit

All Frigidaire codes → All dryer codes →

Frequently asked questions

What does the E64 code mean on a Frigidaire dryer?

The dryer expects current draw through the heating element and sees none — either the element is burned out, a thermal fuse has opened, or there's a break in the heater circuit. Most common Frigidaire dryer code.

What causes the E64 code on a Frigidaire dryer?

Burned-out heating element: Open coil — most common cause. Element resistance reads infinite. Blown thermal fuse on blower housing: Usually a symptom of restricted vent; replace fuse AND clear vent. Open high-limit thermostat: Tripped from prior overheat.

Is it safe to keep using a Frigidaire dryer with a E64 error?

Limited use only. This is rated a serious-severity fault.

How do I fix E64 on a Frigidaire dryer?

Unplug the dryer. Verify 240V at the outlet (both legs hot to ground). Remove rear access panel.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: frigidaire.com.