GE · Dishwasher Moderate

DR — Door Latch / Door Open Fault

DR (or 'door' icon flashing) indicates the door is not detected as fully closed and latched, so the cycle cannot run.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
geappliances.com ↗

How to fix it

  1. Re-rack to clear interference and firmly close the door past the latch detent.
  2. Press Start within 4 seconds of closing the door.
  3. Inspect the door strike on the tub; bend tab gently if misaligned.
  4. Remove the inner door panel and ohm the latch microswitches; replace the latch assembly if a switch is open with the door closed.

Why it happens

Typical signs: DR on display · Cycle won't start after pressing Start · Latch feels loose

  • Door not fully closed User did not push the door past the latch detent within 4 seconds of Start.
  • Rack item blocking door Tall pot handle or utensil preventing the door from closing fully.
  • Failed door latch switch Microswitch in the door latch assembly is open or sticking.
  • Misaligned latch strike Tub latch strike bent or loose, preventing latch engagement.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • GE dishwasher door latch assembly Common replacement
    Amazon →

More GE dishwasher codes

1h 1h — Delay Start Active 888 888 — Display Self-Test / Demo C1 C1 Error — Slow Drain (Over 2 Minutes) C2 C2 Error — Drain Cycle Too Long (Over 7 Minutes) C4 C4 — Overfill / Filled Twice After Power Loss C5 C5 — Underfill / Short Drain Time

All GE codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: geappliances.com.