GE · Dryer Moderate

E8 — Power board model-selector error

Per GE's factory service documentation, E8 is a power-board model configuration error — the fix is to check the model selector setting on the power board, not to service the drive motor.

Keep using it?
Yes, with caution
DIY difficulty
Moderate

How to fix it

  1. Unplug the dryer.
  2. Access the power (main) board and locate the model selector switch or setting.
  3. Verify it matches the configuration specified for this dryer model — check the tech sheet (often stored inside the console or cabinet) or GE service documentation.
  4. Correct the selector if it's set wrong, reassemble, and restore power.
  5. If E8 persists with the selector verified correct, the power board itself is likely at fault and should be replaced or checked by a technician.

Why it happens

Typical signs: E8 on display · Dryer may not run the correct cycle profile for the model · Console shows E8 during startup or cycle selection

  • Model selector on the power board set incorrectly Per GE's factory fault table, E8 points to the model-selector switch/setting on the power board not matching this dryer's configuration.
  • Power board unable to read the model selector If the selector is confirmed correct, the board itself may be faulty.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • GE dryer power control board Common replacement
    Amazon →

More GE dryer codes

E1 E1 — Interface (UI) board EEPROM error E2 E2 — Power board EEPROM error E3 E3 — Inlet thermistor shorted E4 E4 — Inlet thermistor open circuit E5 E5 — Exhaust thermistor circuit fault F01 F01 — Inlet thermistor defective (CleanSpeak models)

All GE codes → All dryer codes →

Frequently asked questions

What does the E8 code mean on a GE dryer?

Per GE's factory service documentation, E8 is a power-board model configuration error — the fix is to check the model selector setting on the power board, not to service the drive motor.

What causes the E8 code on a GE dryer?

Model selector on the power board set incorrectly: Per GE's factory fault table, E8 points to the model-selector switch/setting on the power board not matching this dryer's configuration. Power board unable to read the model selector: If the selector is confirmed correct, the board itself may be faulty.

Is it safe to keep using a GE dryer with a E8 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix E8 on a GE dryer?

Unplug the dryer. Access the power (main) board and locate the model selector switch or setting. Verify it matches the configuration specified for this dryer model — check the tech sheet (often stored inside the console or cabinet) or GE service documentation.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician.