Maytag · Washer Serious

F8E1 — No water detected / long fill

The washer did not detect water entering the tub within the expected time. Almost always a water-supply or inlet-valve issue.

Keep using it?
Limited use only
DIY difficulty
Easy
Verified against
producthelp.maytag.com ↗

How to fix it

  1. Confirm both hot and cold supply valves at the wall are fully open.
  2. Unplug washer; disconnect fill hoses at the back.
  3. Inspect and clean the inlet screens with a small brush.
  4. Check hoses for kinks; replace any that are old or bulging.
  5. If supply is good, test inlet valve solenoids for continuity (~500–1500Ω).
  6. Replace the water inlet valve if a solenoid is open or stuck.

Why it happens

Typical signs: F8E1 on display · Cycle pauses early · No fill sound · Slow trickle fill

  • Water supply turned off Hot or cold valve at the wall is closed.
  • Clogged inlet screens Mesh screens at hose connections clogged with sediment.
  • Kinked fill hose Hose pinched behind washer.
  • Failed inlet valve Solenoid coil open or stuck closed.
  • Low household water pressure Pressure below ~20 psi will trip F8E1.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Maytag water inlet valve Common replacement
    Amazon →
  • Stainless steel fill hoses Common replacement
    Amazon →

More Maytag washer codes

E1 F9 E1 F9 — Long drain time F1E1 F1E1 — Main control board failure F21 F21 — Long Drain / Drain Error F22 F22 — Door lock fault (front-load) F2E1 F2E1 — Stuck key on user interface F33 F33 — Pump driver / electrical fault

All Maytag codes → All washer codes →

Frequently asked questions

What does the F8E1 code mean on a Maytag washer?

The washer did not detect water entering the tub within the expected time. Almost always a water-supply or inlet-valve issue.

What causes the F8E1 code on a Maytag washer?

Water supply turned off: Hot or cold valve at the wall is closed. Clogged inlet screens: Mesh screens at hose connections clogged with sediment. Kinked fill hose: Hose pinched behind washer.

Is it safe to keep using a Maytag washer with a F8E1 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F8E1 on a Maytag washer?

Confirm both hot and cold supply valves at the wall are fully open. Unplug washer; disconnect fill hoses at the back. Inspect and clean the inlet screens with a small brush.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.