Maytag · Washer Serious

LF — Long fill (water supply restriction)

The washer has not reached the required water level within the allotted fill time. Equivalent to F8E1 on newer displays; older Maytags show 'LF'.

Keep using it?
Limited use only
DIY difficulty
Easy
Verified against
producthelp.maytag.com ↗

How to fix it

  1. Open both hot and cold supply valves fully.
  2. Shut off water, disconnect fill hoses, and clean the inlet screens.
  3. Check fill hoses for kinks; straighten or replace.
  4. Test water pressure at the faucet (should be 20–120 psi).
  5. If still failing, replace the water inlet valve.

Why it happens

Typical signs: LF on display · Cycle pauses or cancels during fill · Weak water flow into tub

  • Supply valves not fully open Hot/cold faucets at wall partially closed.
  • Clogged inlet screens Sediment in the mesh at hose connections.
  • Kinked fill hose Hose pinched against wall.
  • Failed inlet valve Solenoid stuck or coil failed.
  • Low water pressure Household pressure under ~20 psi.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Water inlet valve Common replacement
    Amazon →
  • Inlet screen washers Common replacement
    Amazon →

More Maytag washer codes

E1 F9 E1 F9 — Long drain time F1E1 F1E1 — Main control board failure F21 F21 — Long Drain / Drain Error F22 F22 — Door lock fault (front-load) F2E1 F2E1 — Stuck key on user interface F33 F33 — Pump driver / electrical fault

All Maytag codes → All washer codes →

Frequently asked questions

What does the LF code mean on a Maytag washer?

The washer has not reached the required water level within the allotted fill time. Equivalent to F8E1 on newer displays; older Maytags show 'LF'.

What causes the LF code on a Maytag washer?

Supply valves not fully open: Hot/cold faucets at wall partially closed. Clogged inlet screens: Sediment in the mesh at hose connections. Kinked fill hose: Hose pinched against wall.

Is it safe to keep using a Maytag washer with a LF error?

Limited use only. This is rated a serious-severity fault.

How do I fix LF on a Maytag washer?

Open both hot and cold supply valves fully. Shut off water, disconnect fill hoses, and clean the inlet screens. Check fill hoses for kinks; straighten or replace.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.maytag.com.