Whirlpool · Washer Minor

Fd — Factory Default Settings

Whirlpool's OEM documentation states that 'Fd' means the washer was returned to Factory Default settings. It is a status message, not a fault indicating a broken part.

Keep using it?
Yes — fix when convenient
DIY difficulty
Easy
Verified against
producthelp.whirlpool.com ↗

How to fix it

  1. This is a confirmation message, not a repair issue — select and start a cycle as normal.
  2. Reprogram any custom favorites or settings you had saved, since they were reset to factory defaults.
  3. If 'Fd' appears every time you try to start a cycle (not just once after a reset), unplug the washer for a minute to clear a possible stuck control state and try again.
  4. If 'Fd' keeps recurring after that, the electronic control board may need service.

Why it happens

Typical signs: 'Fd' briefly on the display · Custom saved settings or favorite cycles appear reset to factory defaults · Washer otherwise runs and completes cycles normally

  • Washer settings reset to factory default Can happen after a manual reset, certain power interruptions, or a settings change that didn't complete.

More Whirlpool washer codes

dET dET — Detergent Cartridge Not Detected F0E2 F0E2 — Over Suds Detected F0E3 F0E3 — Load Too Heavy / Basket Blocked F0E5 F0E5 — Off-Balance Load F0E7 F0E7 — Clothing Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board (CCU) Fault

All Whirlpool codes → All washer codes →

Frequently asked questions

What does the Fd code mean on a Whirlpool washer?

Whirlpool's OEM documentation states that 'Fd' means the washer was returned to Factory Default settings. It is a status message, not a fault indicating a broken part.

What causes the Fd code on a Whirlpool washer?

Washer settings reset to factory default: Can happen after a manual reset, certain power interruptions, or a settings change that didn't complete.

Is it safe to keep using a Whirlpool washer with a Fd error?

Yes — fix when convenient. This is rated a minor-severity fault.

How do I fix Fd on a Whirlpool washer?

This is a confirmation message, not a repair issue — select and start a cycle as normal. Reprogram any custom favorites or settings you had saved, since they were reset to factory defaults. If 'Fd' appears every time you try to start a cycle (not just once after a reset), unplug the washer for a minute to clear a possible stuck control state and try again.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.whirlpool.com.