Amana · Dishwasher Serious

F6E2 — Water Inlet Valve Failure

The control detected an electrical fault with the water inlet valve circuit.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
amana.com ↗

How to fix it

  1. Disconnect power and remove the lower kickplate.
  2. Inspect wiring to the water inlet valve.
  3. Test the valve coil with a multimeter (~1000-1500 ohms).
  4. Replace the water inlet valve if out of spec.
  5. If the valve is good, the control board may need replacement.

Why it happens

Typical signs: Tub fills very slowly or not at all · Cycle aborts during fill · Audible buzz from valve area

  • Open or shorted inlet valve solenoid Coil winding failed.
  • Broken wire to valve Loose connector or chafed wire.
  • Control board relay failure Output driving the valve burned out.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher water inlet valve Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Lockout Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F4E1 F4E1 — Door Switch Open

All Amana codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.