Amana · Dishwasher Moderate

FAE1 — Vent Wax Motor Fault

The vent or wax motor that opens the vent flap during drying is not operating.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
amana.com ↗

How to fix it

  1. Open the door and inspect the vent assembly on the inner door panel.
  2. Verify the vent flap moves freely by hand.
  3. Disconnect power and test the wax motor for continuity (~2000 ohms).
  4. Replace the vent assembly if the wax motor is open.
  5. Run a cycle and verify the vent opens during drying.

Why it happens

Typical signs: Dishes wet at end of cycle · Poor drying performance · FAE1 displayed

  • Failed vent wax motor Wax actuator burned out.
  • Stuck vent flap Mineral buildup or debris.
  • Broken wiring to vent assembly Loose connector at top of door.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher vent assembly Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Lockout Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F4E1 F4E1 — Door Switch Open

All Amana codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.