Amana · Dishwasher Serious

FBE1 — Motor Communication Fault

The main control board has lost communication with the wash motor controller.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
amana.com ↗

How to fix it

  1. Disconnect power for 5 minutes and retry.
  2. Inspect wiring between the control board and the wash motor.
  3. Test resistance of the circulation pump motor.
  4. Replace the wash motor / circulation pump if defective.
  5. If wiring and motor test good, replace the control board.

Why it happens

Typical signs: No wash action · Cycle aborts shortly after start · Motor doesn't run

  • Failed wash motor / circulation pump Motor electronics damaged.
  • Broken communication wire Harness between control and motor damaged.
  • Failed main control board Communication output failed.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana dishwasher circulation pump motor Common replacement
    Amazon →

More Amana dishwasher codes

Clean Light Flashing 1 Time Clean Light Flashing 1x — Control Lockout Clean Light Flashing 7 Times Clean Light Flashing 7x — Heating Element Failure F1E1 F1E1 — Control Board Failure F2E1 F2E1 — Stuck Key on Control Panel F3E1 F3E1 — Thermistor / OWI Sensor Failure F4E1 F4E1 — Door Switch Open

All Amana codes → All dishwasher codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.