Amana · Washer Moderate

F3E1 — Pressure Switch / Water Level Sensor Fault

The control received an out-of-range reading from the pressure (water level) sensor. The washer can't accurately measure how much water is in the tub.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
producthelp.amana.com ↗

How to fix it

  1. Unplug washer.
  2. Locate the pressure sensor hose (small clear tube to the tub).
  3. Disconnect, inspect for kinks, clean with warm water, and blow through to clear.
  4. Reseat both ends of the hose firmly.
  5. If error persists, replace the pressure sensor.
  6. Replace the ACU only if a new sensor doesn't clear the code.

Why it happens

Typical signs: F3E1 code · Overfilling or underfilling · Washer drains immediately after fill · Cycle won't progress

  • Kinked or detached pressure hose Small air hose between tub and sensor pinched or off.
  • Clogged pressure dome / port Sediment or soap residue blocks the air column.
  • Failed pressure sensor Sensor drifted out of calibration or shorted.
  • Main control fault ACU input circuit reading the sensor failed.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Pressure / water level sensor Common replacement
    Amazon →

More Amana washer codes

F0E1 F0E1 / rL — Clean Washer Cycle Started With a Load Inside F1E1 F1E1 — Main Control Board Failure F21 F21 — Drain time too long F2E1 F2E1 — Stuck Key on User Interface F4E1 F4E1 — Heater Sensor Fault (Steam/Heated Models) F5E1 F5E1 — Lid Switch Fault

All Amana codes → All washer codes →

Frequently asked questions

What does the F3E1 code mean on a Amana washer?

The control received an out-of-range reading from the pressure (water level) sensor. The washer can't accurately measure how much water is in the tub.

What causes the F3E1 code on a Amana washer?

Kinked or detached pressure hose: Small air hose between tub and sensor pinched or off. Clogged pressure dome / port: Sediment or soap residue blocks the air column. Failed pressure sensor: Sensor drifted out of calibration or shorted.

Is it safe to keep using a Amana washer with a F3E1 error?

Yes, with caution. This is rated a moderate-severity fault.

How do I fix F3E1 on a Amana washer?

Unplug washer. Locate the pressure sensor hose (small clear tube to the tub). Disconnect, inspect for kinks, clean with warm water, and blow through to clear.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.amana.com.