Amana · Washer Moderate

F5E1 — Lid Switch Fault

The washer cannot detect the lid switch opening. The control expects the lid to open between cycles to confirm the switch is working.

Keep using it?
Yes, with caution
DIY difficulty
Easy
Verified against
amana.com ↗

How to fix it

  1. Unplug the washer for 1 minute to reset the control.
  2. Open the lid fully, then close it firmly — repeat 2-3 times.
  3. Inspect the lid strike for alignment with the switch slot.
  4. Remove the console and check the lid switch harness for loose pins.
  5. Test the lid switch with a multimeter for continuity when actuated.
  6. Replace the lid switch/lock assembly if it fails the continuity test.

Why it happens

Typical signs: F5E1 displayed on control panel · Washer will not start a new cycle · Lid appears closed but error persists

  • Lid not opened between cycles Open and close the lid once to clear the error on top-load models.
  • Faulty lid switch or lock Switch contacts worn or stuck, preventing the control from seeing a state change.
  • Loose wiring harness to lid switch Vibration can loosen the connector at the switch or main control.
  • Broken lid strike or hinge Strike misaligned so the switch is not fully actuated when lid closes.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Amana lid lock/switch assembly Common replacement
    Amazon →

More Amana washer codes

dL dL / dU — Door/Lid Lock Fault F02 F02 — Long drain / pump fault F0E1 F0E1 / rL — Clean Washer Cycle Started With a Load Inside F1E1 F1E1 — Main Control Board Failure F21 F21 — Drain time too long F2E1 F2E1 — Stuck Key on User Interface

All Amana codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: amana.com.