F8E1 — Long Fill / No Water Detected

How to fix it

1. Verify both hot and cold supply valves are fully open.
2. Disconnect fill hoses and clean the inlet screens.
3. Check fill hoses for kinks; straighten or replace.
4. Test water inlet valve with a multimeter (typical ~1 kΩ per solenoid).
5. Inspect the pressure switch hose for kinks, splits, or sediment.
6. Replace inlet valve or pressure sensor if defective.

Why it happens

Typical signs: F8E1 code · Cycle pauses early · Tub appears empty or partially filled · Slow or no water at the inlet

• Closed or partially closed water supply valves Hot and/or cold faucets behind the washer not fully open.
• Clogged inlet screens Screens at the back of the washer block flow when scaled or full of debris.
• Kinked or crushed fill hoses Bend behind the washer restricts flow below the sensor threshold.
• Faulty water inlet valve Solenoid stuck or coil failed, so valve doesn't open fully on command.
• Pressure switch / sensor hose issue Air hose to the pressure sensor is kinked or off, so control never sees water rise.

Other parts sometimes needed

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

• Inlet screen / filter washers Common replacement
  Amazon →

More Amana washer codes

All Amana codes → All washer codes →