Amana · Washer Serious

F9E1 — Long Drain

Water didn't drain to the expected level within the allowed time. Almost always a flow restriction in the drain path.

Keep using it?
Limited use only
DIY difficulty
Moderate
Verified against
producthelp.amana.com ↗

How to fix it

  1. Cancel cycle and unplug washer.
  2. Drain the tub manually using the drain hose into a low bucket.
  3. Pull the drain hose from the standpipe and check for clogs or kinks.
  4. Access the drain pump and remove debris from the impeller.
  5. Pour water down the standpipe to confirm the house drain accepts it.
  6. Test pump for continuity and 120V at the connector; replace if dead.

Why it happens

Typical signs: F9E1 code · Standing water in the tub at end of cycle · Cycle stops before spin · Slow or no pump-out sound

  • Clogged drain pump filter / debris in pump Coins, lint, or fabric jam the impeller.
  • Kinked or installed-too-high drain hose Hose looped above ~96" or pushed deep into standpipe causes siphoning/restriction.
  • Clogged standpipe or house drain Backup outside the washer prevents water from leaving.
  • Failed drain pump Pump runs but doesn't move water, or doesn't run at all.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More Amana washer codes

F0E1 F0E1 / rL — Clean Washer Cycle Started With a Load Inside F1E1 F1E1 — Main Control Board Failure F21 F21 — Drain time too long F2E1 F2E1 — Stuck Key on User Interface F3E1 F3E1 — Pressure Switch / Water Level Sensor Fault F4E1 F4E1 — Heater Sensor Fault (Steam/Heated Models)

All Amana codes → All washer codes →

Frequently asked questions

What does the F9E1 code mean on a Amana washer?

Water didn't drain to the expected level within the allowed time. Almost always a flow restriction in the drain path.

What causes the F9E1 code on a Amana washer?

Clogged drain pump filter / debris in pump: Coins, lint, or fabric jam the impeller. Kinked or installed-too-high drain hose: Hose looped above ~96" or pushed deep into standpipe causes siphoning/restriction. Clogged standpipe or house drain: Backup outside the washer prevents water from leaving.

Is it safe to keep using a Amana washer with a F9E1 error?

Limited use only. This is rated a serious-severity fault.

How do I fix F9E1 on a Amana washer?

Cancel cycle and unplug washer. Drain the tub manually using the drain hose into a low bucket. Pull the drain hose from the standpipe and check for clogs or kinks.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.amana.com.