Amana · Washer Serious

LF — / Lo FL — Long Fill

Older-style display for the long-fill condition. Water didn't reach the required level in the allowed time.

Keep using it?
Limited use only
DIY difficulty
Easy
Verified against
producthelp.amana.com ↗

How to fix it

  1. Open both faucets fully.
  2. Disconnect fill hoses and clean inlet screens.
  3. Measure water pressure at the supply lines.
  4. Test inlet valve solenoid coils with a multimeter.
  5. Replace inlet valve if a coil is open or shorted.

Why it happens

Typical signs: LF or Lo FL on display · Washer pauses with little water in tub · Audible inlet click but slow fill

  • Supply valves not fully open Hot/cold faucets behind washer partially closed.
  • Clogged inlet screens Mesh filters at hose connection points scaled over.
  • Faulty water inlet valve Solenoid weak or shorted.
  • Low household water pressure Pressure must be 20-120 psi for proper fill.

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

More Amana washer codes

F0E1 F0E1 / rL — Clean Washer Cycle Started With a Load Inside F1E1 F1E1 — Main Control Board Failure F21 F21 — Drain time too long F2E1 F2E1 — Stuck Key on User Interface F3E1 F3E1 — Pressure Switch / Water Level Sensor Fault F4E1 F4E1 — Heater Sensor Fault (Steam/Heated Models)

All Amana codes → All washer codes →

Frequently asked questions

What does the LF code mean on a Amana washer?

Older-style display for the long-fill condition. Water didn't reach the required level in the allowed time.

What causes the LF code on a Amana washer?

Supply valves not fully open: Hot/cold faucets behind washer partially closed. Clogged inlet screens: Mesh filters at hose connection points scaled over. Faulty water inlet valve: Solenoid weak or shorted.

Is it safe to keep using a Amana washer with a LF error?

Limited use only. This is rated a serious-severity fault.

How do I fix LF on a Amana washer?

Open both faucets fully. Disconnect fill hoses and clean inlet screens. Measure water pressure at the supply lines.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: producthelp.amana.com.