Bosch · Refrigerator Moderate

E7 — Ambient (Room) Temperature Sensor Fault

Bosch's official US refrigeration error-code page documents only three entries: E02 (icemaker/ice-water communication), E03 (dispenser UI), and a generic 'E or D' catch-all. A bare 'E7' is not separately documented. The 'ambient (room) temperature sensor fault' explanation below is not confirmed on Bosch's US consumer page — verify against your model's manual, or treat it per Bosch's generic guidance: power-cycle, and call support if it persists.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
bosch-home.com ↗

How to fix it

  1. Unplug for 5 minutes to attempt reset.
  2. Locate the ambient sensor (often integrated into the display assembly or behind the upper grille).
  3. Reseat any connectors found.
  4. Test thermistor resistance at room temperature against the tech-sheet chart.
  5. Replace the sensor if out of spec; replace the UI or main board if the sensor is good.

Why it happens

Typical signs: E7 displayed · Energy use higher than normal · Excessive door sweating · Compressor runs more than expected

  • Failed ambient thermistor Open or shorted sensor element.
  • Disconnected sensor harness Connector at the UI or main board has come loose.
  • Failed UI / main board input Sensor circuit on the PCB has failed.

Replace your water filter

A clogged or overdue water filter is a common cause of low water and ice flow on Bosch refrigerators — they are meant to be changed about every 6 months. The OEM-style filter that fits most Bosch refrigerators is the BORPLFTR10 ($60-75 OEM, $25-35 compatible).

  • Bosch BORPLFTR10 refrigerator water filter OEM water filter
    Amazon →

Not sure which filter fits your model? See the full compatibility guide →

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Bosch refrigerator ambient temperature sensor Common replacement
    Amazon →

More Bosch refrigerator codes

E1 E1 — Fresh-Food Compartment Sensor Fault E10 E10 — Inverter Compressor / Compressor Drive Fault E11 E11 — Display Control Module Fault E12 E12 — Damper Control Fault E2 E2 — Icemaker / Ice-Water System Communication Fault E20 E20 — Defrost Drain Heater / Drain Blockage

All Bosch codes → All refrigerator codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: bosch-home.com.