Frigidaire · Dryer Minor

E68 — Stuck key on user interface

The control sees a button on the keypad held down longer than expected. Usually debris on the keypad, a sticky membrane, or a failed user interface board.

Keep using it?
Yes — fix when convenient
DIY difficulty
Easy
Typical cost
$80-200
Verified against
frigidaire.com ↗

The fix

User interface / keypad

Stuck or shorted keypad button

$80-200 moderate difficulty 1 hour Tools: screwdriver, nut driver

Diagnose first: Indicates a key has been pressed for too long, typically a failed membrane keypad.

Find this part on Amazon →

As an Amazon Associate we earn from qualifying purchases.

How to fix it

  1. Press and release each button one at a time to find any stuck button.
  2. Unplug the dryer for 5 minutes to reset.
  3. Clean the keypad surface and edges with a dry cloth.
  4. If a specific button feels stuck, replace the keypad/UI assembly.
  5. If all buttons feel normal but code persists, replace the user interface board.
  6. Verify panel screws are not over-tightened pressing the membrane.

Why it happens

Typical signs: E68 displays · Dryer won't start · One button feels mushy or always pressed · Random tones from panel

  • Debris or moisture under the keypad Clean panel and try again.
  • Failed membrane keypad Mechanical wear on a frequently used button.
  • Bad user interface (UI) board Sensor circuit failed.
  • Control panel bezel pressing on a button Warped or recently reassembled panel.

More Frigidaire dryer codes

E11 E11 — Control Board Checksum (Memory) Error E4A E4A — Program Time Out Fault E5B E5B — Heater Fault (No Heating) E61 E61 — Heater relay failure on control board E62 E62 — Heater Power Relay Fault E64 E64 — Heating element open circuit

All Frigidaire codes → All dryer codes →

Frequently asked questions

What does the E68 code mean on a Frigidaire dryer?

The control sees a button on the keypad held down longer than expected. Usually debris on the keypad, a sticky membrane, or a failed user interface board.

What causes the E68 code on a Frigidaire dryer?

Debris or moisture under the keypad: Clean panel and try again. Failed membrane keypad: Mechanical wear on a frequently used button. Bad user interface (UI) board: Sensor circuit failed.

Is it safe to keep using a Frigidaire dryer with a E68 error?

Yes — fix when convenient. This is rated a minor-severity fault.

How do I fix E68 on a Frigidaire dryer?

Press and release each button one at a time to find any stuck button. Unplug the dryer for 5 minutes to reset. Clean the keypad surface and edges with a dry cloth.

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: frigidaire.com.