KitchenAid · Washer Serious

F1E1 — Main Control Board Failure

The Central Control Unit (CCU) has detected an internal fault. The board cannot reliably control the wash cycle.

Keep using it?
Limited use only
DIY difficulty
Hard
Verified against
kitchenaid.com ↗

How to fix it

  1. Unplug washer for 5 minutes to attempt soft reset
  2. Restore power and try a cycle
  3. If error returns, unplug and access CCU (top rear panel)
  4. Inspect harness connections for damage or corrosion
  5. Replace the Central Control Unit if no other issues found

Why it happens

Typical signs: F1E1 displayed · Washer unresponsive or stuck mid-cycle · Cycle won't start · Random behavior

  • Defective main control board Internal CCU electronics have failed
  • Power surge damage Voltage spike damaged board components
  • Moisture intrusion Water/humidity reached the control board
  • Loose wire harness Connection to CCU intermittent

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • KitchenAid Main Control Board (CCU) Common replacement
    Amazon →

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F2E1 F2E1 — Stuck Button on User Interface F3E1 F3E1 — Pressure Switch Failure F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock F5E3 F5E3 — Lid Lock Will Not Unlock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.