KitchenAid · Washer Moderate

F3E1 — Pressure Switch Failure

The water level pressure sensor is sending an out-of-range signal. The control cannot accurately determine the water level in the tub.

Keep using it?
Yes, with caution
DIY difficulty
Moderate
Verified against
kitchenaid.com ↗

How to fix it

  1. Unplug washer
  2. Access pressure transducer (top rear)
  3. Disconnect air dome hose and check for kinks, blockages, water
  4. Blow through hose to clear
  5. Check sensor harness connection
  6. Replace pressure transducer if hose is clear

Why it happens

Typical signs: F3E1 displayed · Washer overfills or underfills · Fill cycle hangs · Won't advance past fill

  • Kinked/clogged pressure hose Air tube from tub to sensor blocked
  • Faulty pressure transducer Sensor itself has failed
  • Wiring fault Harness between sensor and CCU damaged

Parts you may need

If diagnosis points to a failed part, these are the common replacements. As an Amazon Associate we earn from qualifying purchases.

  • Pressure Switch / Transducer Common replacement
    Amazon →

More KitchenAid washer codes

F0E1 F0E1 — Load Detected During Clean Washer Cycle F1E1 F1E1 — Main Control Board Failure F2E1 F2E1 — Stuck Button on User Interface F5E1 F5E1 — Lid Switch Fault F5E2 F5E2 — Lid Lock Will Not Lock F5E3 F5E3 — Lid Lock Will Not Unlock

All KitchenAid codes → All washer codes →

Always unplug an appliance before servicing it. This guide is for informational purposes and is not a substitute for a qualified technician. Verified against manufacturer documentation: kitchenaid.com.